307
Chapter 8: Troubleshooting
This chapter covers the following topics:
• VTrak is Beeping (below)
• LEDs Display Amber or Red (page 309)
• CLU Reports a Problem (page 315)
• WebPAM PROe Reports a Problem (page 318)
• LEDs Display Amber or Red (page 309)
• Event Notification Response (page 321)
• Critical & Offline Disk Arrays (page 336)
• Incomplete Array (page 339)
• Physical Drive Problems (page 340)
• Enclosure Problems (page 342)
• Controller Enters Maintenance Mode (page 345)
• Connection Problems (page 348)
• Browser Does Not Connect to WebPAM PROe (page 351)
• Unsaved Data in the Controller Cache (page 352)
VTrak is Beeping
VTrak’s alarm has five different patterns, as shown below.
Figure 1. Audible alarm sound patters
When you first power-up the VTrak, it beeps twice to show normal operation.
The audible alarm sounds at other times to inform you that the VTrak needs
attention. But the alarm does not specify the condition.
.25s.25s.25s
.25s.25s
.25s.25s
.25s.25s .25s
.25s
.25s
.5s
.25s
.5s
.75s
.25s
.75s
.25s
.75s
1s 1.25s
2.5s
3s
1x
2x
1
2
3
4
5
6s
s
8
To Next Page
Loading...
Need help?
General
