Promise Technology VTRAK E610f User Manual

39
Chapter 3: VTrak Setup
This chapter covers the following topics:
• Setting up the Serial Connection (below)
• Choosing DHCP or a Static IP Address (page 40)
• VTrak Default IP Addresses (page 40)
• Setting up VTrak with the CLI (page 41)
• Setting up VTrak with the CLU (page 43)
• Setting Up WebPAM PROe (page 46)
Setting up the Serial Connection
VTrak has a Command Line Interface (CLI) to manage all of its functions,
including customization. A subset of the CLI is the Command Line Utility (CLU), a
user-level interface that manages your VTrak via your PC’s terminal emulation
program, such as Microsoft HyperTerminal. This procedure uses the serial cable
connection you made. “Setting Up Serial Cable Connections” on page 36.
1. Change your terminal emulation program settings to match the following
specifications:
• Bits per second: 115200
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: none
2. Start your PC’s terminal VT100 or ANSI emulation program.
3. Press Enter once to launch the CLI.
4. At the Login prompt, type administrator and press Enter.
5. At the Password prompt, type password and press Enter.
At this point, you are in the CLI. You can continue using the CLI to make
network settings or you can switch to the CLU. Go to:
• Setting up VTrak with the CLI (page 41)
• Setting up VTrak with the CLU (page 43)

Promise Technology VTRAK E610f Specifications

General

Brand	Promise Technology
Model	VTRAK E610f
Category	Storage
Language	English