Promise Technology VTRAK E610f - Chapter 4: Management with Webpam Proe, Cont

Chapter 4: Management with WebPAM PROe
83
5. Click the Port Configuration link for Controller 1 or 2
6. To enable DHCP, check the DHCP box.
When DHCP is NOT enabled, enter:
• Primary IP address
• Primary subnet mask
• Default gateway IP address
• Enter a primary DNS server IP address.
7. Click the Submit button.
8. Click the Maintenance Mode tab again.
9. Click the Port Configuration link for the other controller and repeat the
steps 6 and 7 for the other controller.