Promise Technology VTRAK E610f User Manual

Chapter 5: Management with the CLU
231
Making Telnet Settings
By default, Telnet service is set to Automatic and its normal status is Started.
To make Telnet service settings:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight Telnet and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
5. Highlight the following and press the backspace key to erase the current
value, then type the new value:
• Port number (2300 is the default)
• Session Time Out (24 minutes is the default. 1440 minutes = 24 hours)
• Maximum number of connections (4 is the default)
6. Press Ctrl-A to save your settings.
To start, stop or restart the Telnet service, highlight Start, Stop, or Restart and
press Enter.
Making SSH Settings
By default, Secure Shell (SSH) service is set to Automatic and its normal status is
Started.
To make SSH settings:
1. From the Main Menu, highlight Additional Info and Management and press
Enter.
2. Highlight Software Management and press Enter.
3. Highlight SSH and press Enter.
4. Highlight Startup Type and press the spacebar to toggle between Automatic
and Manual.
5. Highlight the following and press the backspace key to erase the current
value, then type the new value:
• Port number (22 is the default)
• Session Time Out (24 minutes is the default. 1440 minutes = 24 hours)
• Maximum number of connections (4 is the default)
6. Press Ctrl-A to save your settings.

Promise Technology VTRAK E610f Specifications

General

Brand	Promise Technology
Model	VTRAK E610f
Category	Storage
Language	English