RL78/G10 CHAPTER 12 SERIAL ARRAY UNIT
R01UH0384EJ0311 Rev. 3.11 391
Dec 22, 2016
Figure 12-86. Example of Contents of Registers for Address Field Transmission of Simplified I
2
C
(IIC00) (2/2)
(f) Serial output enable register 0 (SOE0)
(g) Serial channel start register 0 (SS0) … Sets only the bits of the target channel is 1.
Note 16-pin products only.
Remarks 1. n = 0, r: IIC number (r = 00)
2. : Setting is fixed in the CSI master transmission mode, : Setting disabled (set to the initial value)
×: Bit that cannot be used in this mode (set to the initial value when not used in any mode)
0/1: Set to 0 or 1 depending on the usage of the user
Symbol: 7 6 5 4 3 2 1 0
SOE0
0
0
0
0
0
0
SOE01
Note
×
SOE00
0/1
SOE0n = 0 until the start condition is generated, and SOE0n = 1 after generation.
Symbol: 7 6 5 4 3 2 1 0
SS0
0
0
0
0
0
0
SS01
×
SS00
0/1
SS0n = 0 until the start condition is generated, and SS0n = 1 after generation.
To Next Page
Loading...
