RL78/G10 APPENDIX A REVISION HISTORY
R01UH0384EJ0311 Rev. 3.11 614
Dec 22, 2016
(6/9)
Edition
Description Chapter
Rev.2.00
Addition of specification and notes 1 to 3 in Table 14-2 Interrupt Source List (16-pin
products)
CHAPTER 14
INTERRUPT FUNCTIONS
Addition of specification, notes 1 and 2 in Table 14-4 Flags Corresponding to Interrupt
Request Sources (16-pin products)
Addition of Figure 14-3 Format of Interrupt Request Flag Registers (IF0L, IF0H, IF1L)
(16-pin product)
Addition of Figure 14-5 Format of Interrupt Mask Flag Registers (MK0L, MK0H, MK1L)
(16-pin product)
Addition of Figure 14-5 Format of Interrupt Mask Flag Registers (MK0L, MK0H, MK1L)
(16-pin product)
Addition of description in 14.3.3 Priority specification flag registers (PR00L, PR00H,
PR10L, PR10H, PR01L, PR11L)
Addition of Figure 14-7 Format of Priority Specification Flag Registers (PR00L, PR00H,
PR10L, PR10H, PR01L, PR11L) (16-pin product)
Addition of remarks 1 and 2 in Figure 14-8 Format of External Interrupt Rising Edge
Enable Register 0 (EGP0) and External Interrupt Falling Edge Enable Register 0 (EGN0)
Modification of description in 15.3.4 Registers controlling port functions of key interrupt
input pins
CHAPTER 15
KEY INTERRUPT FUNCTION
Modification of note 2 in Figure 16-3 STOP Mode Release by Interrupt Request
Generation (2/2)
CHAPTER 16
STANDBY FUNCTION
Modification of Figure 18-2 Timing of Internal Reset Signal Generation
CHAPTER 18
SELECTABLE POWER-ON-
RESET CIRCUIT
Addition of caution in 19.1 Functions of Option Bytes
CHAPTER 19
OPTION BYTE
Addition of caution 2 in Figure 19-2 Format of User Option Byte (000C1H)
Modification of description in Figure 19-3 Format of User Option Byte (000C2H)
Addition of R5F10Y17 in Table 20-6 Processing Time of Each Command When Using
PG-FP5 (Reference Values)
CHAPTER 20
FLASH MEMORY
Addition of R5F10Y17 to note 1 in Figure 21-3 Memory Spaces Where Debug Monitor
Programs Are Allocated
CHAPTER 21
ON-CHIP DEBUG FUNCTION
Addition of addr5 in Table 23-2 Symbols in "Operation" Column
CHAPTER 23
INSTRUCTION SET
Modification of note 2 in Table 23-5 Operation List (1/17) to (17/17)
Modification of description in 24.1 Absolute Maximum Ratings
CHAPTER 24
ELECTRICAL
SPECIFICATIONS
Modification of description in 24.2 Oscillator Characteristics
Modification of description, notes 1 to 4, and caution in 24.3.1 Pin characteristics
Addition of description, notes 1 to 6, and remarks 1 and 2 in (2) Flash ROM: 4 KB of 10-
pin products, and 16-pin products
Addition of description, notes 1 to 6, and remarks 1 to 3 in (3) Peripheral Functions
(Common to all products)
Modification of description in 24.4 AC Characteristics
Addition of figure of Minimum Instruction Execution Time during Main System Clock
Operation
Addition of figure of External System Clock Timing
Modification of TI/TO Timing
Addition of description in 24.5.2 Serial interface IICA
To Next Page
Loading...
Need help?
General
