CMU Base System CMU
1100.4903.12 6.16 E-10
SYSTem:MQUeue[:COMPlete]:ITEM? Next Entry in Measurement Queue
Response
Parameter description Def. value Default unit FW vers.
<FGroup_Mode>,
<MeasObject>
Function group and test mode
Ready measurement
"NONE",
"NONE"
– V2.10
Command description
This command is always a query. It returns and deletes the oldest ready measurement in the measurement
queue.
Reset of Function Groups
The PRESet/RESet subsystem restores the (factory) default values for all instrument settings. It corre-
sponds to the Reset menu opened via the RESET key on the front panel.
SYSTem:PRESet[:ALL] Reset all function groups and test modes
SYSTem:RESet[:ALL]
Command description FW vers.
This command sets all parameters of the instrument to default values. The commands differ for in-
strument settings with distinct default values in manual and remote control (e.g. the repetition mode
for many measurements):
• SYST:PRES restores the default values for manual control, leaving the current remote control
parameters unchanged.
• SYST:RES (available for FW vers. ≥3.10) restores the default values for remote control leaving
the current manual control parameters unchanged. This command is equivalent to *RST.
V1.20
SYSTem:RESet:CURRent Partial Reset
Command description FW vers.
This command sets all parameters of the current function group and test mode to default values.
The command is available in all function groups. In contrast to the Reset menu the command re-
stores the default values defined for remote control operation. In cases where remote and manual
control use distinct settings (e.g. the repetition mode for many measurements), the manual control
settings are left unchanged.
V3.10
To Next Page
Loading...
Need help?
General
