Rohde & Schwarz CMU 200 - Table 1-1 Software Installation with the Versionmanager

Software Update and Version Management CMU
1100.4903.12 1.20 E-10
Activate Activate the current firmware configuration.
Install software...
Install software... opens a list of all firmware installation versions available
on an external storage medium (floppy disk/PCMCIA card). As explained in
Table 1-1, this function depends on the type and number of storage media
and on the number of installation versions available.
Table 1-1 Software installation with the VersionManager
Storage medium with FW
installation version
2
Number of FW
installation versions
VersionManager function
Floppy 1 Install software version <version> from floppy
several Install software from floppy
–> Open software version selection dialog (see below).
PCMCIA card
in slot 0 or 1 (right or left side)
1 Install software version <version> from PC-card slot <slot_no>
several Install software from PC-card slot <slot_no>
–> Open software version selection dialog (see below).
PCMCIA card
in slot 0 and in slot 1
1 (per PC-card) Install software version <version> from PC-card
–> Open PC-card selection dialog (see below).
several Install software from PC-card
–> Open PC-card selection dialog (see below).
PC-card
selection dialog:
The PC-card selection dialog selects either PCMCIA card slot 0 (right side)
or slot 1 (left side) for installation.
2
Media without FW installation versions are ignored.