CMU Error Messages
1100.4903.12 9.5 E-4
Device-specific error
The following errors cause bit 3 in the ESR register to be set.
Error code Explanation
-300
Device-specific error
-310
System error
An unspecified system error has occurred.
-311
Memory error
An error was detected in the device's memory.
-313
Calibration memory lost
Nonvolatile calibration data have been lost.
-314
Save/recall memory lost
Nonvolatile saved data have been lost.
-315
Configuration memory lost
Nonvolatile configuration data saved by the device have been lost.
-330
Self-test failed
An error occurred during the internal self test.
-350
Queue overflow
Error code entered in the queue in lieu of the code when the queue is full. It indicates that an error occurred
but was not recorded in the queue. The original error message is lost.
-360
Communication error
An unspecified communication error was detected.
-361
Parity error in program message
Parity bit was not correct when data were received on a serial port.
-362
Framing error in program message
No stop bit was detected when data were received on a serial port.
-363
Input buffer overrun
Software or hardware input buffer on serial port overflows with data caused by improper or nonexistent
pacing.
To Next Page
Loading...
