Rohde & Schwarz CMU 200 - Page 410

Error Messages CMU
1100.4903.12 9.4 E-4
Error code Explanation
-224
Illegal parameter value
An exact value, from a list of possible values, was expected but not received.
-225
Out of memory
The CMU software has insufficient memory to perform the requested operation.
-230
Data corrupt or stale
Possibly invalid data; new reading started but not completed since last access.
-240
Hardware error
A legal program command or a query could not be executed because of a hardware problem in the device.
-241
Hardware missing
A legal program command or a query could not be executed because of a missing device hardware.
-250
Mass storage error
A mass storage error occurred.
-251
Missing mass storage
A legal program command or a query could not be executed because of missing mass storage.
-252
Missing media
A legal program command or a query could not be executed because of missing media; for example, no
floppy disk.
-253
Corrupt media
A legal program command or a query could not be executed because of corrupt media; for example, bad
floppy disk or wrong format.
-254
Media full
A legal program command or a query could not be executed because of the media was full; for example, no
room on the floppy disk.
-255
Directory full
The specified directory is full – no more files can be written.
-256
File name not found
A file with the specified name does not exist.
-257
File name error
The specified file name cannot be used, e.g. because the file does not exist (reading, clearing) or already
exists (writing, generation).
-258
Media protected
A legal program command or a query could not be executed because the media was protected.