CMU RF Measurements
1100.4903.12 6.29 E-10
TRIGger[:SEQuence]:SOURce:EXTernal <Source> Ext. Trigger (AUX 3/4)
<Source>
Description of parameters Def. value Def. unit FW vers.
PIN6 | PIN7 | PIN8 Pin for external trigger signal PIN8 – V3.10
Description of command
This command determines the pins on the AUX 3 or AUX4 connectors used for the external trigger signal. The
setting only has effect if the trigger source is an External signal.
TRIGger[:SEQuence]:DEFault <Enable> Default Settings
<Enable>
Description of parameters Def. value Def. unit FW vers.
ON |
OFF
The parameters are set to their default values
All or some parameters differ from the default values
ON
– V1.15
Description of command
If used as a setting command with the parameter ON this command sets all parameters of the subsystem to their
default values (the setting OFF has no effect).
If used as a query the command returns whether all parameters are set to their default values (ON) or not (OFF).
To Next Page
Loading...
Need help?
General
