Sel 2414 - Page 153

SET.23
of 36
Date Code 20130214 Instruction Manual SEL-2414 Transformer Monitor
SEL-2414 Settings Sheets
Logic Settings (SET L Command)
Input Debounce Settings (Slot 6)
IN601 Debounce (AC, 0–65000 ms) IN601D :=
IN602 Debounce (AC, 0–65000 ms) IN602D
:=
IN603 Debounce (AC, 0–65000 ms) IN603D
:=
IN604 Debounce (AC, 0–65000 ms) IN604D
:=
IN605 Debounce (AC, 0–65000 ms) IN605D
:=
IN606 Debounce (AC, 0–65000 ms) IN606D
:=
IN607 Debounce (AC, 0–65000 ms) IN607D
:=
IN608 Debounce (AC, 0–65000 ms) IN608D
:=
Front-Panel Access Control
Data Reset
Target Reset (SV) RSTTRGT :=
Reset Energy (SV) RSTENRGY
:=
Reset Max/Min (SV) RSTMXMN
:=
Reset Demand (SV) RSTDEM
:=
Reset Peak Demand (SV) RSTPKDM
:=
Access Control
Disable FP Settings Change (SV) DSABLSET :=
Time Synchronization Source
TIME_SRC IRIG Time Source (Select: IRIG1, IRIG2) TIME_SRC :=
Voltage Ratio Correction Factors (only visible when SELECT 3 ACI/3 AVI 0–8 Vac card
installed)
VARCF Ratio Correction Factor (Range = 0.500–1.500) VARCF :=
VBRCF Ratio Correction Factor (Range = 0.500–1.500) VBRCF
:=
VCRCF Ratio Correction Factor (Range = 0.500–1.500) VCRCF
:=
Event Messenger Points
MESSENGER POINT TRIGGER (Off, 1 Device Word bit) MPTR1 :=
MESSENGER POINT AQ (None, 1 analog quantity) MPAQ1
:=
MESSENGER POINT TEXT (148 characters) MPTX1
:=
MESSENGER POINT TRIGGER (Off, 1 Device Word bit) MPTR2
:=
MESSENGER POINT AQ (None, 1 analog quantity) MPAQ2
:=
MESSENGER POINT TEXT (148 characters) MPTX2
:=
MESSENGER POINT TRIGGER (Off, 1 Device Word bit) MPTR3
:=
MESSENGER POINT AQ (None, 1 analog quantity) MPAQ3
:=
MESSENGER POINT TEXT (148 characters) MPTX3
:=
MESSENGER POINT TRIGGER (Off, 1 Device Word bit) MPTR4
:=
MESSENGER POINT AQ (None, 1 analog quantity) MPAQ4
:=
MESSENGER POINT TEXT (148 characters) MPTX4
:=
MESSENGER POINT TRIGGER (Off, 1 Device Word bit) MPTR5
:=
MESSENGER POINT AQ (None, 1 analog quantity) MPAQ5
:=
MESSENGER POINT TEXT (148 characters) MPTX5
:=