ST STM32F410 - Digital-To-Analog Converter (DAC); Introduction; DAC Main Features

RM0401 Rev 3 243/771
RM0401 Digital-to-analog converter (DAC)
256
12 Digital-to-analog converter (DAC)
12.1 Introduction
The DAC module is a 12-bit, voltage output digital-to-analog converter. The DAC can be
configured in 8- or 12-bit mode and may be used in conjunction with the DMA controller. In
12-bit mode, the data could be left- or right-aligned. An input reference voltage, V
REF+
(shared with ADC), is available. The output can optionally be buffered for higher current
drive.
12.2 DAC main features
• One DAC converter
• Left or right data alignment in 12-bit mode
• Synchronized update capability
• Noise-wave generation
• Triangular-wave generation
• DMA capability
• DMA underrun error detection
• External triggers for conversion
• Input voltage reference, V
REF+
Figure 40 shows the block diagram of a DAC channel and Table 51 gives the pin
description.