RM0401 Rev 3 91/771
RM0401 Reset and clock control (RCC)
134
5 Reset and clock control (RCC)
5.1 Reset
There are three types of reset, defined as system Reset, power Reset and backup domain
Reset.
5.1.1 System reset
A system reset sets all registers to their reset values except the reset flags in the clock
controller CSR register and the registers in the Backup domain.
A system reset is generated when one of the following events occurs:
1. A low level on the NRST pin (external reset)
2. Window watchdog end of count condition (WWDG reset)
3. Independent watchdog end of count condition (IWDG reset)
4. A software reset (SW reset) (see Software reset)
5. Low-power management reset (see Low-power management reset)
Software reset
The reset source can be identified by checking the reset flags in the RCC clock control &
status register (RCC_CSR).
The SYSRESETREQ bit in Cortex
®
-M4 with FPU Application Interrupt and Reset Control
Register must be set to force a software reset on the device. Refer to the Cortex
®
-M4 with
FPU technical reference manual for more details.
To Next Page
Loading...
Need help?
General
