3.10.6 Changing parameters
3.10.6.1 Activating and exiting the setting mode
You must activate the setting mode to change the different settings.
GUID-B400A8E6-2B79-40EA-ADF9-00C4E557179E
1. Agroline instrument panel display setting switch
1. Activate the setting mode.
With the power switched on and the clock function selected, press and hold
down the symbol side of the display setting switch for more than three
seconds, until the display is in the setting mode (in 12 or 24 hours display)..
You can modify the following parameters:
Parameter
Parameter value
Display backlight level 1–7
Hour display Hours
Minute display Minutes
Clock mode 12–hour or 24–hour
Tyre parameters 100---400
Go to the other settings by pressing the symbol side of the change over switch.
2. Exit the setting mode.
Press and hold down the symbol side of the display setting switch for more
than three seconds. Also, if the setting mode is not altered for over 10
seconds, the display changes into the normal mode.
3.10.6.2 Setting the display backlight level
GUID-3AB1A278-DA72-45AC-8F10-B0F75142D207
1. Backlight level
3. Operation
- 149 -
To Next Page
Loading...
Need help?
General
