EasyManuals Logo

Valtra HiTech T3 Series User Manual

Valtra HiTech T3 Series
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #71 background imageLoading...
Page #71 background image
After starting a cold engine, the glow indicator light can light up again. The
afterglow reduces white smoke and keeps the cold engine running smoothly.
3.3.2 Starting under cold conditions
To ensure a successful start under cold conditions, use the engine heater and
follow the instructions given.
IMPORTANT: If you start the engine when it is very cold, the indicator light for
blocked hydraulic filters can be lit. This indicates that the oil is going through the
by-pass valve unfiltered.
IMPORTANT: Avoid using hydraulics until the oil has warmed up and the
indicator light is no longer lit.
IMPORTANT: Always use the engine heater when the temperature is below 0°C.
IMPORTANT: If you are driving the tractor for a short distance only, make sure
that the battery is charged enough to ensure starting.
NOTE: Use of the engine heater reduces the wear on the engine.
• When cold starting the engine, turn off all unnecessary equipment that uses
electrical power.
• Keep the battery in a warm place when it is not in use.
Starting the tractor under very cold conditions is easier if the battery is kept in
a warm place when it is not in use.
• Use the engine heater to ensure a successful start under cold conditions.
Warming up the engine for 2–3 hours before starting is sufficient.
When the engine heater is activated, you can hear a hissing sound.
• If you start the engine under very cold conditions, keep the ignition key in the
starting position until the engine has started.
IMPORTANT: Do not keep the ignition key in the starting position for more
than 30 seconds at a time.
• If the temperature is below 0°C, first, warm up the engine and hydraulics oil
for a while at low engine speed.
Allow the engine to run for a few minutes before starting to drive or engaging
the power take-off. When first starting to use hydraulic functions, use the
predefined factory setting M2 to set the maximum flow to 50% for the first few
minutes.
• Never race a cold engine.
Run the engine with a light load until it has reached its normal operating
temperature.
3. Operation
- 70 -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Valtra HiTech T3 Series and is the answer not in the manual?

Valtra HiTech T3 Series Specifications

General IconGeneral
BrandValtra
ModelHiTech T3 Series
CategoryTractor
LanguageEnglish

Related product manuals