GUID-436251D4-B48E-4EEF-A554-E4C85B3B11BA
1. Engine oil pressure
2. Stop light (is flashing)
3. Gearbox oil pressure
4. Four-wheel drive
5. Parking brake
6. Battery charging
1. Check that the power shuttle lever is in the parking brake position.
2. Turn the hand throttle knob to the low idling position.
3. Switch on the main switch.
4. Ensure that the control stop (extra equipment) is deactivated.
5. Turn the ignition key to the power on position
.
6. Wait until the glow indicator light
on the instrument panel has gone out.
7. Turn the ignition key to the starting position .
• When the engine starts to fire up, keep the ignition key in the starting
position until the engine has started.
• If the engine fails to start within 10 seconds, stop starting and try again.
8. Release the ignition key when the engine starts.
When the engine starts, the following indicator lights go out:
• Engine oil pressure
• Gearbox oil pressure
• Stop light
• Battery charging
9. Use the accelerator pedal to control the engine speed.
IMPORTANT: Never race a cold engine.
3. Operation
- 69 -
To Next Page
Loading...
Need help?
General
