4.8.4 Using twin-mounted wheels
Twin-mounted wheels can be used for decreasing the surface pressure, but not
for obtaining better side support.
1. Multiply the loading by 1.76 of the permissible load on one wheel.
IMPORTANT: Do not exceed the maximum permitted axle loading even if the
tyres allow a heavier load.
2. If dual/extension wheels are used, check that the tyre size does not exceed
the permissible tyre values.
3. Adjust the track width of the inner wheels to the minimum value.
4. Adjust the turning angle, if necessary.
4.8.5 Engine
4.8.5.1 Bleeding the fuel system
After changing the fuel filters or if the engine has ran out of fuel the fuel system
has to be bled.
GUID-79534247-056E-4CED-B3B1-C1292C029555
1. Hand pump
2. Bleeding plug
WARNING: The fuel system connectors are not allowed to be opened
when the engine is running and not for 30 seconds after switching off
the engine. The pressure in the engines can be over 1 000 bar. If the
jet of the high pressure fuel comes in contact with your skin, the fuel
penetrates the skin and causes serious injuries. Contact your doctor
immediately.
WARNING: Only an authorised person is allowed to repair the fuel
system.
1. Open the bleeding plug.
2. Put a transparent hose in the plug hole and lead it into a suitable container.
4. Maintenance
- 311 -
To Next Page
Loading...
Need help?
General
