3.3.3 Starting with an auxiliary battery
You can start the engine with an auxiliary battery (jump starting).
WARNING: A fully charged battery connected directly to a dead
battery can cause a current surge capable of causing the batteries to
explode.
IMPORTANT: Never try to start the engine by short-circuiting leads.
1. Check that the auxiliary battery has the same voltage as the standard battery.
2. Open the battery plugs to avoid risk of explosion.
3. Connect the (+) terminal of the auxiliary battery to the (+) terminal on the
tractor battery.
4. Connect the other jump lead from the (-) terminal of the auxiliary battery to
the attaching bolt of the battery ground wire or some other convenient ground
(not to the battery terminal).
5. Start the engine.
6. When the engine has started, disconnect the jump leads in the following order:
• Disconnect the jump lead between the ground and the (-) terminal of the
auxiliary battery.
• Remove the jump lead between the (+) terminals.
3.4 Using lights
3.4.1 Using headlights
GUID-1272AE0F-D762-4BA3-B93D-720193D6D7C1
1. Light switch
2. Multifunctional lever
• To switch on the parking lights, turn the light switch to the centre position.
When the switch is in this position, the working lights can also be switched on.
3. Operation
- 71 -
To Next Page
Loading...
Need help?
General
