Valtra HiTech T3 Series User Manual

• In freezing weather, ensure that the transmission oil and hydraulic oil are
warm before engaging the PTO.
Before engaging the PTO in freezing weather:
• let the engine run for a few minutes to warm up the transmission oil
• let the hydraulic oil warm up for a few minutes with the maximum flow of
50%. To adjust the flow, select the factory setting for medium output
(50%) with the selector for the predefined factory/user settings.
• When engaging the PTO, wait approximately 5 seconds until the clutch of the
PTO shaft is totally engaged before loading it.
3.17.2 Rear power take-off
You can use power take-off (PTO) to transmit power from the tractor to an
implement.
The PTO shaft is a splined driveshaft that is easily connected and disconnected.
The rear power take-off controls are the following:
2
3
1
A
U
T
O
A
U
T
O
M
I
N
M
A
X
P
GUID-68B50B75-940B-46EE-B50D-F6F3BB0B3C95
1. Switch for rear PTO
2. Switch for rear PTO automatic stop (extra equipment)
3. Speed control lever for the rear PTO
The rear PTO on/off push button on the rear mudguard is extra equipment:
3. Operation
- 194 -

Valtra HiTech T3 Series Specifications

General

Brand	Valtra
Model	HiTech T3 Series
Category	Tractor
Language	English