• To start the rear PTO with the PTO switch:
• Activate the standby mode by setting the rear PTO switch to the standby
(centre) position.
• Start the rear PTO by pressing down the symbol side of the PTO switch
and releasing it.
The indicator light on the instrument panel is lit.
GUID-135DF10F-1DC4-4E6B-A81C-6FF0F38FCCCD
1. Switch for rear PTO
• To start the rear PTO with the rear PTO on/off push button (extra equipment):
GUID-4958FCFB-0B02-4AE3-A231-8C8F0D00D3C3
1. Rear PTO on/off push button
• Set the rear PTO switch to the standby position (centre) before leaving
the tractor.
• Press the rear PTO on/off push button continuously for at least 3 seconds.
The PTO starting begins after 0.5 seconds. If the pressing is interrupted
during these 3 seconds, the PTO stops.
3.17.2.4 Stopping rear power take-off temporarily
You can stop the rear power take-off (PTO) temporarily in the following ways:
• By using the rear PTO switch.
• By using the rear PTO speed control lever.
• By using the rear PTO on/off push button (extra equipment) on the rear
mudguard.
3. Operation
- 198 -
To Next Page
Loading...
Need help?
General
