Preprogrammed Powershift gear symbol
The preprogrammed Powershift gear symbol (1, 2, or 3) flashes if there is
preprogrammed Powershift gears and the power shuttle lever is in P or N position.
When the forward driving direction is selected the preprogrammed Powershift
gear symbol for reverse driving direction (1, 2, or 3) is shown.
When the reverse driving direction is selected the preprogrammed Powershift
gear symbol for forward driving direction (1, 2, or 3) is shown.
Preprogrammed driving direction symbol
The preprogrammed driving direction symbols (F and R) flashes in turns when
there is a preprogrammed driving direction and the power shuttle lever is in P or
N position.
When the forward driving direction is selected the preprogrammed driving
direction symbol for reverse driving direction (R) is shown.
When the reverse driving direction is selected the preprogrammed driving
direction symbol for forward driving direction (F) is shown.
3.11.2 Transmission section
GUID-1552EFD4-3FFF-4DFE-BBE8-5026D01FE6F6
1. Creeper speed range symbol
2. Shifting automatics symbol
3. Selected Powershift gear
4. Automatic traction control symbol
Shifting automatics symbol
The gear wheel symbol and number 1 or 2 show which mode of shifting
automatics is in use. Number 1 indicates that the shifting automatics programme
1 is in use, and number 2 indicates that the shifting automatics programme 2 is in
use. When the shifting automatics is not selected, these symbols are not visible
and the manual shifting is in use.
Selected Powershift gear
The number of the engaged Powershift gear is shown in the middle of the
transmission section 1, 2, or 3.
3. Operation
- 153 -
To Next Page
Loading...
Need help?
General
