EasyManuals Logo

Valtra HiTech T3 Series User Manual

Valtra HiTech T3 Series
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #278 background imageLoading...
Page #278 background image
automatic valves for water draining. The valve functions must be checked
frequently.
1
GUID-47DD9E97-2BBD-4154-BBE5-37D85C7EB0F9
1. Automatic water draining valve
1. Push a blunt stick through the draining valve hole.
IMPORTANT: The stick must not be sharp, because it can damage the valve.
If the air that comes out is free of water, the automatic is operating.
2. If there is water with the air, push the stick through the valve hole until there
is no pressure on the container.
3. Open the valve and clean the seal inside it.
4. Mount the valve back.
5. Check the valve on the other side.
6. If the valves do not operate properly after cleaning, replace them with new ones.
4.7.4.17 Adjusting engine valves
Contact an authorised Valtra workshop for the engine valve adjustment.
NOTE: The engine valves must be adjusted after 500 operating hours. After the
first adjustment, adjust the valves every 1 000 hours.
4.7.5 Maintenance every 1000 hours or yearly
4.7.5.1 Changing oil in the hydraulic system
Both hydraulic and transmission oil can be used in the hydraulic system. The use
of transmission oil is recommended, since hydraulic oil may mix with oils from
other tractors through implements and thereby damage other tractors. The
hydraulic system is filled with transmission oil at the factory.
4. Maintenance
- 277 -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Valtra HiTech T3 Series and is the answer not in the manual?

Valtra HiTech T3 Series Specifications

General IconGeneral
BrandValtra
ModelHiTech T3 Series
CategoryTractor
LanguageEnglish

Related product manuals