Valtra HiTech T3 Series User Manual

3
6
4 5
2
1
AUT
O
A
U
T
O
M
I
N
M
A
X
P
GUID-3951B793-8011-47F1-8F6A-E74887EC0912
1. Lifting height selector
2. Draft control selector
3. Pick-up hitch latch releasing switch
4. Lift/stop/lower switch
5. Passing switch for the position control knob
6. Position control knob
1. Set the lifting height selector to max position.
2. Set the draft control selector to position P.
3. Set the position control knob to position 8.
4. Press down the side opposite to the symbol of the lift/stop/lower switch.
5. Press down simultaneously the passing switch for the position control knob
and the pick-up hitch latch releasing switch.
The pick-up hitch latch unlatches.
6. Press down the symbol side of the lift/stop/lower switch.
NOTE: Make sure that the linkage is activated (the diagnose light is not lit).
Keep the pick-up hitch latch releasing switch pressed down.
The linkage lowers below the latching point (to the position set by the position
control knob).
7. Release the pick-up hitch latch releasing switch.
8. Use the position control knob to lower the linkage as required.
3. Operation
- 214 -

Valtra HiTech T3 Series Specifications

General

Brand	Valtra
Model	HiTech T3 Series
Category	Tractor
Language	English