10. Close the drain plug of the oil cooler.
11. Loosen the hose placed between the thermostat housing and expansion tank.
GUID-F779F6A0-0D85-49E0-8CB5-BB4E1DC26E39
1. Hose
12. Check that the restrictor hole (Ø about 2 mm) in the union is open.
13. Refasten the hose.
14. Fill the system to the fluid level mark on the expansion tank.
Mix the anti-freeze and water according to the manufacturer’s instructions.
GUID-D791CABC-224C-413F-B481-0048C8F42CE2
1. Fluid level mark
NOTE: Always use a recommended coolant.
IMPORTANT: Never fill up with cold fluid while the engine is warm.
IMPORTANT: Do not use plain water as coolant.
After changing the fluid, run the engine for a while and check the level of the fluid.
4. Maintenance
- 299 -
To Next Page
Loading...
Need help?
General
