WARNING: The parking brake does not engage at driving speeds over
2 km/h. If you move the power shuttle lever to the P position at higher
driving speeds, the parking brake indicator light on the instrument
panel and the P symbols on the A-pillar display flash and the buzzer
alarms intermittently until the speed drops below the limitAlways
ensure that the parking brake is actually engaged before leaving the
tractor.
WARNING: In turbine clutch models, always apply the parking brake
or block the wheels when parking. The transmission in these models
does not brake.
1. Stop the tractor completely.
2. Pull up the collar round the power shuttle lever, and move the lever to the
parking brake (P) position.
GUID-28B1703E-60BB-469D-AB73-6C9211A740A7
In some situations (for example, after working with a heavy load) when you
engage the parking brake, the engine may perform cooling of the after-
treatment system by increasing the idling RPM momentarily. The word COOL
flashes on the A-pillar display.
IMPORTANT: Do not stop the engine when the idling RPM is increased.
Stopping the engine may damage the after-treatment system.
When the parking brake is on, four-wheel drive (4WD) is engaged and all
wheels brake.
3. To release the parking brake, pull up the collar, and move the power shuttle
lever away from the parking brake (P) position.
3. Operation
- 93 -
To Next Page
Loading...
Need help?
General
