Name: WAGO PFC100
Brand: WAGO
Rating: 4 (1 reviews)
To Next Page
To Previous Page
Table of Contents  WAGO-I/O-SYSTEM 750 
    750-8100 PFC100; 2ETH; ECO 
Manual   
Version 1.6.0, valid from FW Version 03.02.02(14)   
8.1.12.1  “Global MAC Address Filter State” Group ............................. 119 
8.1.12.2  “MAC Address Filter State Xn” Group ................................... 120 
8.1.12.3  “MAC Address Filter Whitelist” Group ................................... 120 
8.1.13  “Configuration of User Filter” Page ............................................ 121 
8.1.13.1  “User Filter” Group ................................................................ 121 
8.1.13.2  “User Filter n” Group ............................................................. 121 
8.1.13.3  “Add New User Filter” Group ................................................. 122 
8.1.14  “Configuration of Time and Date” Page ..................................... 123 
8.1.14.1  “Date on Device” Group ........................................................ 123 
8.1.14.2  “Time on Device” Group ........................................................ 123 
8.1.14.3  “Time Zone” Group ............................................................... 124 
8.1.14.4  “TZ String” Group .................................................................. 125 
8.1.15  “Configuration of the Users for the Web-based Management” Page126 
8.1.15.1  “Change Password for Selected User” Group ....................... 126 
8.1.16  “Create Bootable Image” Page .................................................. 127 
8.1.16.1  "Create Bootable Image from Active Partition (<Active 
Partition>" Group .................................................................. 127 
8.1.17  “Configuration of Service Interface” Page .................................. 128 
8.1.17.1  “Service Interface assigned to” Group ................................... 128 
8.1.17.2  “Assign Owner of Service Interface (enabled after next 
controller reboot)” Group ....................................................... 128 
8.1.18  “Reboot Controller” Page ........................................................... 129 
8.1.18.1  “Reboot Controller” Group ..................................................... 129 
8.1.19  “Firmware Backup” Page ........................................................... 130 
8.1.20  “Firmware Restore” Page .......................................................... 132 
8.1.21  “System Partition” Page ............................................................. 134 
8.1.21.1  “Current Active Partition” Group ............................................ 134 
8.1.21.2  “Set Inactive Partition Active” Group ..................................... 134 
8.1.22  “Mass Storage” Page ................................................................. 135 
8.1.22.1  “<Device Name>” Group(s) ................................................... 135 
8.1.22.2  “<Device Name> - create new filesystem” Group(s) .............. 135 
8.1.23  “Software Uploads” Page........................................................... 136 
8.1.23.1  “Upload New Software” Group .............................................. 136 
8.1.23.2  “Activate New Software” Group ............................................. 136 
8.1.24  “Configuration of Network Services” Page ................................. 137 
8.1.24.1  “Telnet” Group ...................................................................... 137 
8.1.24.2  “FTP” Group .......................................................................... 137 
8.1.24.3  “FTPS” Group ....................................................................... 137 
8.1.24.4  “HTTP” Group ....................................................................... 138 
8.1.24.5  “HTTPS” Group ..................................................................... 138 
8.1.24.6  “WAGO-I/O-CHECK” Group .................................................. 138 
8.1.24.7  “OPC UA” Group ................................................................... 139 
8.1.25  “Configuration of NTP Client” Page ........................................... 140 
8.1.25.1  “NTP Client Configuration” Group ......................................... 140 
8.1.25.2  “NTP Single Request” Group ................................................ 140 
8.1.26  “Configuration of PLC Runtime Services” Page ......................... 141 
8.1.26.1  “General Configuration” Group .............................................. 141 
8.1.26.2  “e!RUNTIME” Group ............................................................. 141 
8.1.27  “SSH Server Settings” Page ...................................................... 142 
8.1.27.1  “SSH Server” Group .............................................................. 142 