wsm M7040 - CABIN Model

REAR AXLE
M6040, M7040, WSM
4-S5
(2) CABIN Model
Rear Axle Case
1. Remove the cylinder support (2).
2. Support the cabin and remove the cabin mounting bolt (1).
3. Disconnect the hydraulic brake hoses.
4. Remove the rear axle case mounting screws and nuts.
5. Support the rear axle case with nylon lift strap and hoist.
6. Separate the rear axle case from transmission case.
IMPORTANT
• Be sure to support the rear axle and make sure the balance
for support position.
• Hoist up and support the rear axle under neath as shown
photo.
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to joint
face of the rear axle case and transmission case, after eliminate
the water, oil and stuck liquid gasket.
• Align the brake cam (4) and groove "a" of brake cam plate (3).
• Be sure to assemble the cabin mount as shown figure.
• Be sure to bleed the air from the hydraulic brake system.
9Y1210143RAS0005US0
Tightening torque
Cabin mounting bolt and
nut (M14, 7T)
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
Rear axle mounting screw
(M14, 9T)
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123.0 to 144.3 lbf·ft
Rear axle mounting nut
(M14, 6T)
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
(1) Cabin Mounting Bolt
(2) Cylinder Support
(3) Brake Cam Plate
(4) Brake Cam
a: Groove
KiSC issued 07, 2012 A