wsm M7040 - CABIN Model

STEERING
M6040, M7040, WSM
7-S6
Steering Controller
1. Disconnect the shuttle cable (7).
2. Disconnect the power steering delivery hose 1 (1) and hose 2
(3) from power steering controller.
3. Disconnect the oil cooler pipes (2) and (4).
4. Remove the steering controller mounting screws (5) and
steering controller (6).
(When reassembling)
• Be sure to assemble the power steering delivery hose to original
position.
• After assembling the power steering controller, be sure to adjust
the shuttle lever "Neutral" position.
9Y1210143STS0008US0
(2) CABIN Model
Bonnet
1. Open the bonnet (3) and disconnect the battery negative
terminal.
2. Disconnect the connector (2) for head lights.
3. Disconnect the dampers (1).
4. Remove the bonnet (3).
IMPORTANT
• When disconnecting the battery cables, disconnect the
grounding cable first. When connecting, positive cable
first.
(When reassembling)
• Connect the engine harness (6) connector and head light
harness (4) connector within the space of controller pipe (5),
heater hose (7) and delivery hose (8) as shown photo.
9Y1210143STS0009US0
Tightening torque
Power steering delivery
hose retaining nut
22.6 to 27.5 N·m
2.3 to 2.8 kgf·m
16.6 to 20.3 lbf·ft
Controller pipe retaining nut
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
Oil cooler pipe retaining nut
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
Power steering controller
mounting screw
48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.5 to 41.2 lbf·ft
(1) Power Steering Delivery Hose 1
(2) Oil Cooler Pipe
(3) Power Steering Delivery Hose 2
(4) Oil Cooler Pipe
(5) Screw
(6) Steering Controller
(7) Shuttle Cable
(1) Damper
(2) Connector
(3) Bonnet
(4) Wire Harness (Head Light)
(5) Controller Pipe
(6) Wire Harness (Engine)
(7) Heater Hose
(8) Delivery Hose
KiSC issued 07, 2012 A