wsm M7040 - Check Points of Every 600 Hours; Check Point of Every 800 Hours; Check Point of Every 1500 Hours; Check Points of Every 3000 Hours

GENERAL
M6040, M7040, WSM
G-33
[8] CHECK POINTS OF EVERY 600 HOURS
Replacing Engine Oil Filter
1. See page G-19.
9Y1210143GEG0038US0
Changing Transmission Fluid
1. See page G-21.
9Y1210143GEG0039US0
Changing Front Differential Case Oil
1. See page G-21.
9Y1210143GEG0040US0
Changing Front Axle Gear Case Oil
1. See page G-21.
9Y1210143GEG0041US0
Adjusting Front Axle Pivot
1. If the front axle pivot pin adjustment is not correct, front wheel
vibration can occur causing vibration in the steering wheel.
 Adjusting Procedure
1. Loosen the lock nut (1), screw-in the adjusting screw (2) until
seated, then tighten the screw (2) with an additional 1/6 turn.
Re-tighten the lock nut (1).
9Y1210143GEG0042US0
[9] CHECK POINT OF EVERY 800 HOURS
Adjusting Engine Valve Clearance
1. See page 1-S14.
9Y1210143GEG0043US0
[10] CHECK POINT OF EVERY 1500 HOURS
Checking Fuel Injection Nozzle (Injection Pressure)
1. See page 1-S21.
9Y1210143GEG0044US0
[11] CHECK POINTS OF EVERY 3000 HOURS
Checking Injection Pump
1. See page 1-S20.
9Y1210143GEG0045US0
Checking Turbocharger
1. See page 1-S22.
9Y1210143GEG0046US0
Tightening torque Lock nut
98.1 to 147.1 N·m
10.0 to 15.0 kgf·m
72.3 to 108.5 lbf·ft
(1) Lock Nut (2) Adjusting Screw
KiSC issued 07, 2012 A