TRANSMISSION
M6040, M7040, WSM
3-S24
[4] SEPARATING CLUTCH HOUSING CASE FROM TRANSMISSION
CASE
(1) Preparation for CABIN Model
Removing Cabin from Body
1. Refer to "[2] DISASSEMBLING AND ASSEMBLING" on page
10-S33.
9Y1210143TRS0038US0
Hydraulic Pipe
1. Remove the 3-point hitch delivery pipe 2 (1).
2. Remove the 3-point hitch delivery pipe 1 (2) with outlet block (4).
3. Remove the hydraulic pipe (5).
4. Remove the power steering pipe (3).
(When reassembling)
9Y1210143TRS0039US0
(2) Preparation for ROPS Model
Removing ROPS Upper
1. Loosen the ROPS under frame (4) mounting screws. (Do not
remove screws.)
2. Remove the ROPS upper frame (1).
(When reassembling)
• To assemble the ROPS, fix the upper frame with screw (2) and
pin (3) temporarily, then tighten the under frame screws evenly
with specified torque.
• Adjust the upper frame with screws (2) so not to fall down.
9Y1210143TRS0040US0
Tightening torque
3-point hitch delivery pipe
retaining nut
107.9 to 117.7 N·m
11.0 to 12.0 kgf·m
79.6 to 86.8 lbf·ft
Power steering pipe and
hydraulic pipe retaining nut
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
Joint screw for hydraulic
pipe
29.4 to 34.3 N·m
3.0 to 3.5 kgf·m
21.7 to 25.3 lbf·ft
(1) 3-Point Hitch Delivery Pipe 2
(2) 3-Point Hitch Delivery Pipe 1
(3) Power Steering Pipe
(4) Outlet Block
(5) Hydraulic Pipe
Tightening torque
ROPS under frame
mounting screw (M16, 9T)
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
ROPS upper frame lift up
force at center of upper
frame
Reference value
245.2 to 284.2 N
25.0 to 29.0 kgf
55.1 to 63.9 lbf
(1) ROPS Upper Frame
(2) Screw
(3) Pin
(4) ROPS Under Frame
To Next Page
Loading...