wsm M7040 - ROPS Model; Separating Engine and Clutch Housing Case

TRANSMISSION
M6040, M7040, WSM
3-S20
[3] SEPARATING ENGINE AND CLUTCH HOUSING CASE
(1) ROPS Model
Accelerator Wire, Fuel Hose and Wire Harness
1. Disconnect the accelerator wire (4) and fuel hose (2).
2. Disconnect the wire harness from water temperature sensor (3),
engine speed sensor (5) and glow plug (1).
3. Disconnect the fuel hose (9) from fuel filter.
4. Disconnect the 2P connector (10) from alternator (11) and wire
harness from alternator B terminal (6).
5. Disconnect the wire harness from the engine oil pressure switch
(8).
6. Disconnect the 3P connector (7) from engine stop solenoid.
9Y1210143TRS0028US0
Oil Cooler Pipe
1. Remove the fuse boxes (2) and wire harness (1).
2. Disconnect the oil cooler pipe (3).
9Y1210143TRS0029US0
Steering Support Under Cover and Rear Bonnet
1. Remove the steering support under cover (1).
2. Remove the rubber sheet (3) and disconnect the 3-1P
connectors (2).
3. Remove the shield assembly (6).
4. Loosen the rear bonnet mounting screws (8).
5. Remove the seal (4) and panel guide mounting screw (5).
6. Disconnect the wire harness and remove the rear bonnet (7).
9Y1210143TRS0030US0
(1) Glow Plug
(2) Fuel Hose (Return)
(3) Water Temperature Sensor
(4) Accelerator Wire
(5) Engine Speed Sensor
(6) Alternator B Terminal
(7) 3P Connector
(8) Engine Oil Pressure Switch
(9) Fuel Hose
(10) 2P Connector
(11) Alternator
Tightening torque Oil cooler pipe retaining nut
49.0 to 68.6 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
(1) Wire Harness
(2) Fuse Box
(3) Oil Cooler Pipe
(1) Steering Support Under Cover
(2) 1P Connectors
(3) Rubber Sheet
(4) Seal
(5) Screw
(6) Shield
(7) Rear Bonnet
(8) Screw
KiSC issued 07, 2012 A