wsm M7040 - 2 Servicing Specifications

TRANSMISSION
M6040, M7040, WSM
3-S3
2. SERVICING SPECIFICATIONS
Item Factory Specification Allowable Limit
[ROPS Model]
• Main Shift Rod 1
• Main Shift Rod 2
[CABIN Model]
• Main Shift Rod 1
• Main Shift Rod 2
Length
Length
Length
Length
262 mm
10.32 in.
359 mm
14.13 in.
287 mm
10.95 in.
447 mm
17.6 in.
–
–
–
–
[CABIN Model]
• Range Gear Shift Rod 1
• Range Gear Shift Rod 2
Length
Length
193 mm
7.6 in.
368 mm
14.49 in.
–
–
Damper Disc Boss to Gear Shaft Backlash
(Displacement
Around Disc Edge)
– 2.0 mm
0.079 in.
Valve Lever Pin to Lever Bushing
•Lever Pin
• Lever Bushing
Clearance
O.D.
I.D.
0.049 to 0.156 mm
0.0019 to 0.0061 in.
13.957 to 13.984 mm
0.5495 to 0.5506 in.
14.033 to 14.113 mm
0.5525 to 0.5556 in.
0.5 mm
0.0197 in.
–
–
Clutch Pedal Shaft to Clutch Pedal
Bushing
• Clutch Pedal Shaft
• Clutch Pedal Bushing
Clearance
O.D.
I.D.
0.03 to 0.25 mm
0.0012 to 0.0098 in.
24.9 to 25.0 mm
0.9803 to 0.9843 in.
25.03 to 25.15 mm
0.9854 to 0.9902 in.
0.4 mm
0.0157 in.
–
–
Gear on 1st Shaft Side Clearance Less than
0.2 mm
0.0078 in.
–
Internal Circlip to Belleville Washer
(Cupped Spring Washer) of Shuttle
Hydraulic Pack
[Hydraulic Shuttle Model]
Clearance 1.8 to 2.0 mm
0.071 to 0.079 in.
3.6 mm
0.142 in.
Shift Fork to Shift Groove (for Main Change
Section and Range Section)
Clearance 0.15 to 0.40 mm
0.0059 to 0.0157 in.
0.80 mm
0.031 in.
Spiral Bevel Pinion Shaft Only Turning Torque 2.94 to 3.43 N·m
0.3 to 0.35 kgf·m
2.17 to 2.53 lbf·ft
–
Spiral Bevel Gear to Spiral Bevel Pinion
Shaft
Backlash 0.2 to 0.3 mm
0.0079 to 0.0118 in.
0.4 mm
0.016 in.
KiSC issued 07, 2012 A