FRONT AXLE
M6040, M7040, WSM
6-S6
Adjusting between Bevel Gear Case and Stopper
1. Inflate the tires to the specified pressure.
2. Steer the wheels to the extreme right until the knuckle arm (1)
contacts with the bevel gear case (2).
3. If the knuckle arm (1) can not be contacted with the bevel gear
case (2), shorten the length of stopper (3).
4. Keeping the knuckle arm (1) contact with the bevel gear case
(2), make a specified length as shown in the table.
5. After adjustment, secure the stopper with the lock nut (4).
6. For adjusting the left steering angle, perform the same
procedure as mentioned in right steering angle.
9Y1210143FAS0007US0
[2] PREPARATION
(1) Separating Front Axle
Draining Front Axle Gear Case (Right and Left) and Front
Differential Case Oil
1. See page G-10 and G-21.
9Y1210143FAS0008US0
Clearance between
bevel gear case and
stopper "L"
Factory specification
Below
0.5 mm
0.02 in.
(1) Knuckle Arm
(2) Bevel Gear Case
(3) Stopper
(4) Lock Nut
(5) Front Gear Case
L: Clearance
To Next Page
Loading...
