GENERAL
M6040, M7040, WSM
G-21
Changing Transmission Fluid
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug (1) at the bottom of
the transmission case and drain the oil completely into the oil
pan.
2. After draining reinstall the drain plug.
3. Fill with the new KUBOTA SUPER UDT fluid up to the upper
notch on the dipstick (2). (See page G-10.)
4. After running the engine for a few minutes, stop it and check the
oil level again; add oil to prescribed level.
• Do not operate the tractor immediately after changing the
transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
9Y1210143GEG0013US0
Changing Front Differential Case Oil and Front Axle Case Oil
1. To drain the used oil, remove the drain plugs at the both front
axle gear cases and filling plugs, and drain the oil completely
into the oil pan.
2. After draining reinstall the drain plugs (1).
3. Remove the oil level check plugs (3).
4. Fill the new oil for the both front axle gear cases.
5. Fill the new oil up to the check plug port on the front differential
case. (See page G-10.)
6. After checking oil is visible through the opening of the check
plug, reinstall filling plugs and check plugs.
9Y1210143GEG0014US0
Oil capacity
56 L
59.2 U.S.qts
49.3 lmp.qts
(1) Drain Plug
(2) Dipstick
(3) Oil Inlet
(A) Oil level is acceptable within the
range.
Oil capacity
Front axle gear case
3.5 L
3.7 U.S.qts
3.1 lmp.qts
for each side
Front differential case
[M6040, M7040]
5.5 L
5.8 U.S.qts
4.8 lmp.qts
Front differential case
[M7040-SPA]
5.0 L
5.3 U.S.qts
4.4 lmp.qts
(1) Drain Plug
(2) Filling Port
(3) Check Plug
To Next Page
Loading...
