b. To install a new feed roll, squeeze both ends of the new roll shaft, insert and release the roll
ends into the notches.
5. Replace the separator roll:
a. To remove the roll from the assembly, squeeze the orange shafts of the separator roll and lift
out of the assembly.
b. Install a new separator roll into the black notches of the assembly using the same technique.
6. Reinstall the separator roll assembly into the tray.
a. Align the cutout holes of the assembly with the frame of the tray so the pin holes match up.
b. Insert the assembly into the frame.
Xerox
®
Versant
®
4100 Press
User Documentation
269
Working With
To Next Page
Loading...
