Xerox WorkCentre 7132 User Guide

15 Problem Solving
428 Xerox WorkCentre 7132 User Guide
071-210
071-212
An error occurred when using Tray 1. Turn the machine off and on. Contact the
Xerox Welcome Center if the problem persists.
072-210
072-212
An error occurred when using Tray 2. Turn the machine off and on. Contact the
Xerox Welcome Center if the problem persists.
073-210
073-212
An error occurred when using Tray 3. Turn the machine off and on. Contact the
Xerox Welcome Center if the problem persists.
077-215 An error occurred when using Two Tray Module. Turn the machine off and on.
Contact the Xerox Welcome Center if the problem persists.
078-210 An error occurred when using High Capacity Feeder Tray 1. Turn the machine
off and on. Contact the Xerox Welcome Center if the problem persists.
078-211 An error occurred when using High Capacity Feeder Tray 2. Turn the machine
off and on. Contact the Xerox Welcome Center if the problem persists.
081-799 The fax job was cancelled due to the fax transmission limit when sending the job
using e-mail. Try executing the job again.
116-220 Download failed to start after switching to download mode. Contact the Xerox
Welcome Center.
116-701 Unable to print double-sided due to insufficient memory. Check if memory is
installed correctly. If memory is installed correctly, and not being able to identify
the cause of the problem, contact the Xerox Welcome Center.
116-702 Printing was performed using a substitute font. Check the print data.
116-703 An error occurred during PostScript processing. Either confirm the print data, or
open spool settings on the details tab in the print driver to disable bi-directional
communication.
116-713 The job was printed out in parts because the hard disk ran out of space. Delete
unnecessary data.
116-714 A HP-GL/2 command error occurred. Check the print data.
116-720 An error occurred during printing due to insufficient memory. Close unused ports
or delete unnecessary data.
116-740 A numerical value operation error occurred, because the print data contains a
value that exceeds the limit of the printer. Check the print data.
116-749 The print job was stopped, because the specified font was not found. Install the
font or enable font replacement in the print driver.
116-752 There was a warning in the PDF print job ticket description. Repeat the same
procedure. Contact the Xerox Welcome Center if the problem persists.
Code Description and Remedy
Downloaded From ManualsPrinter.com Manuals

Xerox WorkCentre 7132 Specifications

General

Brand	Xerox
Model	WorkCentre 7132
Category	All in One Printer
Language	English