5-39
Starter motor
TIP:
Make sure that the clutch assembly “1” does
not come out from the pinion shaft “2”.
7. Install the pinion shaft assembly “1”, the
lever “2”, a new rubber seal “3”, the plan-
etary gears “4”, the outer gear “5”, and
the plate “6”.
8. Align the protrusion “a” on the stator “1”
with the slot “b” in the cover assembly
“2”, and then assemble the starter motor.
9. Install the spring “1”, pinion “2”, pinion
stopper “3”, and clip “4”.
10. Install a new gasket “1”, the spring “2”,
and the magnet switch “3”.
Installing the starter motor
1. Install the starter motor to the power unit.
See “Installing the starter motor” (7-21).
3
3
c1
2
2
b
a
b
c
1
a
C
1
2
2
1
4
3
5
6
1
ab
2
1
2
1
2
3
4
3
2
2
3
2
1
3
To Next Page
Loading...
