Yamaha F150A - Installing the Speed Sensor

3-15
Optional equipment
Installing the speed sensor
See 6Y8 Multifunction Meter set up manual
for details of the components.
1. Remove the speedometer hose “1” from
the rigging grommet “2”, and then cut off
the tip “a” of the nipple “3”.
2. Cut the extension hose “1” to 300.0 mm
(11.8 in).
3. Install the extension hose “1” to the nip-
ple “2”, and then fasten it using the plas-
tic tie “3”.
4. Cut the corrugated tube “1” to 300.0 mm
(11.8 in).
5. Cut the corrugated tube “2” to 270.0 mm
(10.6 in).
6. Install the corrugated tubes “1” and “2”.
7. Install the speed sensor “1” to the speed
sensor adapter “2”, and then tighten the
speed sensor “1” to the specified torque.
8. Remove the bracket “1”.
9. Connect the extension hose “1” to the
speed sensor adapter “2”, and then
install the speed sensor adapter “2”.
W
2
1
a
a
1
1
2
3
a
2
1
3
Speed sensor “1”:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
1
2
1
2
1
2
1