Yamaha F150A - Rigging Information 3

Rigging information 3
Important reminder on rigging ......................................... 3-1
Outboard motor mounting instructions ...................................... 3-1
Crate handling ................................................................... 3-2
Crate top cover pictograph description ...................................... 3-2
Uncrating ........................................................................... 3-3
Uncrating procedure .................................................................. 3-3
External dimensions ......................................................... 3-5
F150A, FL150A, F150B, FL150B .............................................. 3-5
Clamp bracket ........................................................................... 3-6
Outboard motor mounting ................................................ 3-7
Installing the outboard motor ..................................................... 3-7
Rigging grommet mounting ............................................. 3-9
Rigging grommet description ..................................................... 3-9
Installing the shift cable ............................................................. 3-9
Installing the throttle cable ....................................................... 3-11
Installing the 6Y8 Multifunction Meter harness ........................ 3-12
Installing the conventional gauge harness .............................. 3-12
Installing the main wiring harness ........................................... 3-13
Installing the rigging grommet ................................................. 3-13
Optional equipment ........................................................ 3-14
Installing the isolator lead ........................................................ 3-14
Installing the water pressure sensor ........................................ 3-14
Installing the speed sensor ...................................................... 3-15
Installing the tilt limiter ............................................................. 3-16
Setting the tilt limiter ................................................................ 3-18
Deactivating the tilt limiter ....................................................... 3-20
Y-COP (standard for European market and
optional for Oceanian market) ....................................... 3-20
Installing Y-COP ...................................................................... 3-20
Registering the receiver ID to the ECM ................................... 3-20
Battery installation .......................................................... 3-22
Battery wiring without house (accessory) battery .................... 3-22