Yamaha F150A - Removing the PTT Unit

9-34
PTT unit
0
1
2
3
4
5
6
7
8
9
10
A
Removing the PTT unit
When removing the PTT unit with the
power unit installed, make sure to sus-
pend the outboard motor.
1. Fully tilt the swivel bracket up, and then
support it using the tilt stop lever “1”.
2. Remove the plastic ties “1”, and then pull
out the PTT motor lead from the clamp
bracket (PORT).
3. Disconnect the ground lead “1”.
4. Remove the circlip “1” and upper mount-
ing shaft “2”.
5. Connect the battery jumper leads to the
PTT motor lead “1” to fully retract the
PTT rams.
6. Remove the lower mounting shaft “1”,
and then remove the PTT unit “2”.
1
1
1
1
1
Ram PTT motor lead Battery
Retract
Green (G) (+)
Blue (L) (–)
1
2
L
G
1
2
1