162
Accutome A-Scan Plus User’s Guide
*Note: For more information on setting the Auto mode refer
to "How to Set the Auto Mode" on page 141 of this
manual.
Another aspect of the Auto Mode that is established in
the Accutome A-Scan Plus setup is the Restart feature.
If ’Restart’ is set to ’ON’ and less than five
measurements have been taken, the Auto mode restarts
measurement after automatic capture. The Restart
setting is available on the Setup screen, by pressing the
Preferences button and then the More Settings... soft
menu selection, or by pressing the Preferences button
twice.
*Note: For more information on setting the Auto mode refer
to "Restart On/Restart Off" on page 148 of this
manual.
Manual Mode
Using the manual mode of capture you determine when
a waveform is good and capture it manually.
To Next Page
Loading...
