172
Accutome A-Scan Plus User’s Guide
How to Adjust the Cornea Gate
The cornea gate should be located before the start of
the cornea echo. The active gate is displayed with
dashed line while gates/threshold are indicated by dotted
lines.
To adjust the cornea gate:
1. Press the button beneath the Gate selections until
the "Gate Cornea" is displayed.
Tip: You can use CTRL+C to select the Cornea Gate
directly from the keyboard, or hold to select
cornea gates for all measurements.
2. Rotate the knob to move the cornea gate close to
the cornea echo.
3. When the gate is in the proper position, either
press the the button beneath the gate selections to
select another gate for adjustment or press the
button beneath "Done", the knob or the
√ button to
deactivate the menu.
Figure 118 Cornea Gate Selected
To Next Page
Loading...
