246
Accutome A-Scan Plus User’s Guide
How to Adjust Parameters on Saved Records
You can adjust any of the waveform parameters on a
saved record in exactly the same manner as you would
on an active waveform.
To adjust parameters refer to the section "Performing
Measurements" on page 151 of this manual.
How to Update Calculations
You can update calculations on a saved record in exactly
the same manner as you would perform a calculation on
an active measurement.
To update calculations refer to the section "Performing
Calculations" on page 197 of this manual.
*Note: Changing a saved patient record does not change
the saved record, and the patient record must be
saved again. You may also want to delete the
previously saved patient so that there is only one
record of that patient.
To Next Page
Loading...
