57
How to Use the Buttons and Screens Screens
Soft Menus
Each screen has selections that will perform functions
that change according to the screen.
Tips
One of the features that makes the Accutome A-Scan
Plus so intuitive to use is the tips available on every
screen. The tips are displayed at the top left of each
screen. The message displayed describes the currently
selected screen element.
Sounds
The Accutome A-Scan Plus will also provide you with
audio cues.
There is a constant tone initiated when the probe
contacts the eye. The frequency of the tone increases
the closer the waveform is to being acceptable according
to the criteria established in the Auto Mode.
A high continuous tone indicates valid measurements.
No tone is emitted if the waveform cannot be measured.
A quick double beep is emitted when the waveform is
automatically captured. When you have completed
capturing five waveforms the instrument will emit a high
pitched chirp, indicating completion.
A confirmation beep sounds after a patient is saved and
after a patient is recalled.
Error Messages
There are certain situations where the Accutome A-Scan
Plus will provide an error message, as well as the tones
indicating error. Error messages will be displayed when
there is a problem with printing or any condition that
requires user attention.
Moving between Screens
When moving from a high level to a lower level screen
you only have to press the button beneath the menu item
that indicates the lower level screen.
To Next Page
Loading...
