Accutome a-scan plus - Connecting the Footswitch; Connecting the Printer

19
Getting Started Assembling the Accutome A-Scan Plus
Connecting the Printer
To install the printer:
1. Locate the printer connector, on the side, at the left
of the instrument (see Figure 6 on page 22).
2. Connect the printer cable from the printer to the
printer connector.
3. Set the printer driver according to the printer con-
nected (see "How to Set the Printer" on page 91 of
this manual).
WARNING! THE PRINTER IS
NOT HOT SWAPABLE
AND THE
INSTRUMENT AND
THE PRINTER
SHOULD BE
TURNED OFF WHEN
CONNECTING THE
PRINTER.
Connecting the Footswitch
To connect the footswitch:
1. Locate the footswitch connector, on the side, at the
left of the instrument (see Figure 6 on page 22).
2. Insert the connector of foot switch cable into the
foot switch connector.