Accutome a-scan plus - Accutome Probe with an Immersion Shell; Figure 10 Accutome Probe; Figure 11 Probe Setup with Immersion Shell

26
Accutome A-Scan Plus User’s Guide
Accutome Probe with an Immersion Shell
The Accutome probe is designed to be used with an
Immersion Shell. When using an immersion shell ensure
that there is a distance of 5 - 14.5 mm between the
bottom of the probe and the bottom of the immersion
shell, as shown in
Figure 11 below
Figure 10 Accutome Probe
5 - 14.5 mm
Probe
Immersion Shell
Shell Bottom
Figure 11 Probe Setup with Immersion Shell