Accutome a-scan plus - Connecting the Serial Link

21
Getting Started Assembling the Accutome A-Scan Plus
Connecting the Serial Link
The settings required for the computer that will be
connected to the serial link port are as follows:
 The baud rate can be set to 9600, 19200,
38400, 57600, or 115200.
 The communication parameters are 1 start bit,
8 data bits, 1 stop bit, no parity, hardware flow
control
To utilize the serial link port, you must connect a serial
cable from the serial link connector to an empty serial
port on the PC. The cable required is required is a DB-9
Male to DB-9 Female Straight Through serial cable,
Accutome part number 24-4012. You must also
configure the serial link port in the Setup Screen. (Refer
to
"How to Set the Serial Link" on page 96 of this
manual.)
1. Locate the serial port connector, on the side, at the
left of the instrument (see
Figure 6 on page 22).
2. Insert the serial cable connector of the into the
serial link connector.