Aeroflex 9102 - Selecting the measurement mode; Preparative steps; Selecting the measurement unit

9
9102 Handheld Spectrum Analyzer Software version 5.31 143
Chapter 9 Reflection Operation
This chapter describes the instrument’s functions that are specific to
the
reflection mode. Topics discussed in this chapter are as follows:
– “About the reflection mode” on page 144
– “Selecting the measurement mode” on page 145
– “Preparative steps” on page 145
– “Changing the frequency settings” on page 146
– “Reflection calibration” on page 149
– “Changing the units settings” on page 150
– “Setting up the level parameters” on page 151
– “Performing a limited number of measurements” on page 154
– “Setting up the trace” on page 154
– “Storing and loading traces” on page 158
– “Using limits” on page 159
– “Viewing the reflection mode parameters” on page 160