Chapter 16 SCPI Command Reference
General commands
9102 Handheld Spectrum Analyzer Software version 5.31
259
*CAL
*OPT
*CLS
*IDN
Syntax
*CAL?
Parameters
There are no parameters.
Command
The command form is not available.
Query
Returns the date of the last calibration by Aeroflex in the format yyyy,
mm,dd.
Example
*CAL?
Returns 2004,04,01.
Syntax
*OPT?
Parameters
There are no parameters.
Description
The command form is not available.
Query
Example
*OPT?
Syntax
*CLS
Parameters
There are no parameters.
Command
Resets the entire status reporting system:
– The service register will be cleared (all bits will be set to 0).
– The event status register will be cleared (all bits will be set to 0).
– The error message queue will be emptied.
– All event-type registers will be cleared.
Query
There is no query form of this command available.
Syntax
*IDN?
Parameters
There are no parameters.
Command
There is only a query form of this command available.
Query
Returns a string, containing the following information:
– manufacturer's name
– name of the device
– serial number
– software revision number
All parameters are separated by commas.
Note: In times of company mergers and acquisitions, it is a good idea to
check the name of the device, not the manufacturer's name which may
change between software updates. This does not preclude any name
changes at Aeroflex but rather applies to instrumentation in general.
To Next Page
Loading...
